• 本帖最后由 psdshow 于 2015-6-24 23:18 编辑 *

First of all disable monitoring, once disabled, boot into rescue mode (netboot) from the Kimsufi control panel. Wait a few minutes and an email will show up in your inbox with the details (username and password) of the rescue system.
Login at the rescue system using PuTTy (or your favorite SSH client) and follow the following steps.

Important information for Windows Server 2012 R2 & 2008 R2: After you have fully downloaded the template and performed a reboot to the hard disk, the server will ping for about 20-25 seconds the first time, after that it will time out again, and about 1-2 minutes later it will ping again. This is because of the Driver installation of the network card. This will only happen one time at the first boot.

Type the following command in the console

For Windows Server 2012 R2 (Also works on Online.net) (Guaranteed to work on All Kimsufi Servers) **爱国者捣蛋 发表于 2015-3-14 22:39
发tk换节点试试?
新加坡的机子
有好技术的没好线路**
看我头像

防水。