• 本帖最后由 yonlee 于 2018-6-22 10:57 编辑 *

官方指导 https://wiki.hetzner.de/index.php/LSI_RAID_Controller/en
**
在Rescue模式下
**连接ssh
查看已有raid信息

  • megacli -LDInfo -Lall -Aall复制代码

示例 RAID 1:

  • Adapter 0 -- Virtual Drive Information:
  • Virtual Disk: 0 (Target Id: 0)
  • Name:
  • RAID Level: Primary-1, Secondary-0, RAID Level Qualifier-0
  • Size:697.560 GB
  • State: Optimal
  • Stripe Size: 64 KB
  • Number Of Drives:2
  • Span Depth:1
  • Default Cache Policy: WriteBack, ReadAhead, Cached, Write Cache OK if Bad BBU
  • Current Cache Policy: WriteBack, ReadAhead, Cached, Write Cache OK if Bad BBU
  • Access Policy: Read/Write
  • Disk Cache Policy: Enabled
  • Encryption Type: None
  • - Exit Code: 0x00复制代码

设置raid
查看 Enclosure Number 和 Slot Number

  • megacli -PDList -aAll | egrep "Enclosure Device ID:|Slot Number:|Inquiry Data:|Error Count:|state"复制代码

注意,如果你的status是"Unconfigured (bad)",请使用以下命令(我没用过)

  • megacli -PDMakeGood -PhysDrv[:] -a0复制代码

清除已有设置
删除逻辑分区

  • megacli -CfgLdDel -Lall -aAll复制代码

或,删除所有(我用的这个)

  • megacli -CfgClr -aAll复制代码

设置raid0

  • megacli -CfgLdAdd -r0 [:,:] WB RA Direct CachedBadBBU -a0复制代码

磁盘1的 Enclosure Number
磁盘1的 Slot Number

设置raid1

  • megacli -CfgLdAdd -r1 [:,:] WB RA Direct CachedBadBBU -a0复制代码

我买的是一块300gSAS,两块3T盘,我的设置是这样的

  • megacli -CfgLdAdd -r0 [252:2] WB RA Direct CachedBadBBU -a0复制代码- megacli -CfgLdAdd -r0 [252:0,252:1] WB RA Direct CachedBadBBU -a1复制代码

设置可启动阵列
我不确定这个是做什么的,反正我设置了,dd正常

查看可启动阵列,可启动阵列不存在

  • root@rescue ~ # megacli -AdpBootDrive -get -a0
  • - Adapter 0: No Virtual drive or Physical Drive is configured as boot drive.
  • - Exit Code: 0x00复制代码

设置a0位为可启动阵列

  • root@rescue ~ # megacli -AdpBootDrive -set -L0 -a0
  • - Boot Virtual Drive is set to #0 (target id #0) on Adapter 0
  • - Exit Code: 0x00复制代码